Cisco NCS 2000 series Troubleshooting Manual page 579

Error Messages
Error/Warning
ID
EID-5220
EID-5221
WID-5221
EID-6000
EID-6001
EID-6002
EID-6003
EID-6004
EID-6005
EID-6006
EID-6008
WID-6009
WID-6010
WID-6011
EID-6012
Error/Warning Message
The time slot selected does not match the payload.
The ODU-1 selected does not match the payload.
Deleting the following OCH TRAIL circuit(s) will
cause the Layer2 services (SVLAN, EVC and MPLS
TP Tunnel) provisioned on them to go PARTIAL.
This platform does not support power monitoring
thresholds.
One of the XC cards has failures or is missing.
One of the XC cards is locked.
The OSC termination could not be created. This ring
ID is already assigned.
A system reset cannot be performed while a BLSR ring
is provisioned on the node.
The timing references could not be assigned. - Only
two DS1 or BITS interfaces can be specified. - DS1
interfaces cannot be retimed and used as a reference. -
BITS-2 is not supported on this platform.
The timing references could not be assigned. - An NE
reference can only be used if the timing mode is LINE.
- A BITS reference can only be used if the timing mode
is not LINE. - A Line reference can only be used if the
timing mode is not EXTERNAL.
SF BER and SD BER are not provisionable on the
protect line of a protection group.
If autoadjust GFP buffers is disabled, GFP buffers
available must be set to an appropriate value based on
the distance between the circuit endpoints.
If auto detection of credits is disabled, credits available
must be set to a value less than or equal to the number
of receive credits on the connected FC endpoint.
Ingress idle filtering should be turned off only when
required to operate with non-Cisco Fibre
Channel/FICON-over-SONET equipment.
The retiming configuration could not be changed
because there are circuits on this port.
Description
Select the correct payload.
Select the correct payload.
Refer to the error message text.
Refer to the error message text.
Check whether all the cross-connect
cards are installed and working.
Unlock the cross-connect card.
Enter a new ID for the ring.
Remove the BLSR from the node and
continue with the reset procedure.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
You cannot change the timing
configuration on this port unless the
circuits on this port are deleted.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
533