Cisco NCS 2000 series Troubleshooting Manual page 530

Error Messages Reference
Error/Warning
ID
EID-2024
EID-2025
EID-2026
EID-2027
EID-2028
EID-2029
EID-2030
EID-2031
EID-2032
EID-2033
EID-2034
EID-2035
EID-2036
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
484
Error/Warning Message
An error occurred during node selection.
This feature cannot be used. Verify that each endpoint
of this circuit is running software that supports this
feature.
The {0} request could not be applied. {1}
An error occurred while deleting the circuit drop.
An error occurred while removing the circuit node.
The requested operation is not supported.
An error occurred during provisioning.
An error occurred while adding the node.
The circuit could not be renamed. {0}
An error occurred during validation. {0}
Network circuits could not be added: {0}
The source and destination nodes are not connected.
The {0} cannot be deleted. LAN Access has been
disabled on this node and this {0} is needed to access
the node.
Error Messages
Description
There was an error during node
selection.
Refer to the error or warning message
text. For example, this error is
generated from the node view
Provisioning> WDM-ANS> tabs to
indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card
view (Ethernet card only), where it
indicates that the back-end spanning
tree protocol (STP) disabling is not
supported.
Error occurred while attempting to
switch a path protection circuit away
from a span.
CTC could not delete the circuit drop.
CTC could not remove the circuit
node.
The task you are trying to complete is
not supported by CTC.
There was an error during
provisioning.
There was an error while adding a
node.
CTC could not rename the circuit.
There was an internal error while
validating the user changes after the
Apply button was pressed. This error
can occur in the Edit Circuit dialog
box or in the BLSR table in the shelf
view (rare condition).
Refer to the error message text.
Refer to the error message text.
You cannot delete the DCC/GCC link
as it is needed to access the node.