Fe-Frcdwkswbk-Span - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
DETAILED STEPS
Clear the root-cause service-affecting alarm by using one of the following procedures, as appropriate:
• Clear the LOS (OTS) Alarm, on page 277
• Clear the LOS (TRUNK) Alarm, on page 279
• Clear the LOS-P (OCH) Alarm, on page 284
• Clear the LOS-P (AOTS, OMS, OTS) Alarm, on page 282
• Clear the LOS-P (TRUNK) Alarm, on page 288
• Clear the OPWR-LFAIL Alarm, on page 327
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

FE-FRCDWKSWBK-SPAN

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STMN
The Far End Forced Switch Back to WorkingSpan condition is raised on a far-end 1+1 protect port when it
is Force switched to the working port.
Note WKSWBK-type conditions apply only to nonrevertive circuits.
Clear the FE-FRCDWKSWBK-SPAN Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear a 1+1 Force or Manual Switch Command, on page 445
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Clear a 1+1 Force or Manual Switch Command, on page 445
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
FE-FRCDWKSWBK-SPAN
http://www.cisco.com/c/en/us/support/index.html
procedure for the far-end port.
procedure for the far-end port.
http://www.cisco.com/c/en/us/support/index.html
197