Schlage PIB300 User Manual page 109

Appendix C: Old Board Configuration Information
Setting the DIP Switches
!
NOTE
End of Line
Termination
76
DIP Switch settings perform three tasks for the Hand Reader (see Figure 17-11).
Set End of Line (EOL) Termination to match the type of termination the network being
used needs.
• Set the Communication Method to match the type of network used.
• Erase Memory to clear Hand Reader memory to all factory default values and also
clear all user memory.
Refer to Figure 17-2 on page 66 for the location of all DIP switches described in this
section.
If a Hand Reader is used as a stand-alone Hand Reader, the End of Line (EOL)
Termination and Communication Method dip switches are not used and should be left in
their default positions.
5 4
TOP OF HAND READER
The factory default setting is for EOL termination to be disabled – switches 1 and 2 OFF.
Refer to Figure 17-11 for switch ON/OFF positioning.
• To enable EOL termination at a Hand Reader, both switches 1 and 2 must be ON.
• To disable EOL termination at a Hand Reader, both switches 1 and 2 must be OFF.
• In a Master/Remote Hand Reader network, the Master reader and the last Remote
reader in the daisy-chain must have EOL termination turned ON. All other readers in
the network must have EOL termination turned OFF.
• In a Hand Reader/host PC network, a modem/host PC network, the last Remote
reader in the daisy-chain must have EOL termination turned ON.
• In an Ethernet / host PC network the EOLs must be turned OFF.
WALL
3 2 1
O F F
O N
EOL Termination
EOL Termination
Communication Method
Erase Hand Reader Setup
Erase Hand Reader Setup and Database
Figure 19-16: Hand Reader Dip Switches