Reset Signaling Configuration - 3Com CoreBuilder 9000 User Manual

196 C 7: C
HAPTER ONFIGURING
Reset Signaling
Configuration
V C
IRTUAL HANNELS
Reset the signaling configuration parameters for the CoreBuilder 9000
ATM Enterprise Switch to their factory default settings. All signaling
timers are set to default as UNI and the UNI version is set to 3.0. The reset
takes effect immediately.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Confirm Reset
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 7
The following prompt appears:
Do you really want to reset config? (Y/N) Y
Enter to confirm,
Y N
Signaling Configuration was set to defaults.
The signaling configuration parameters are set to their factory values.
(1) SET: Switch setup
(4) SIG: Signaling Setup
(7) SIG: Set signaling configuration
to factory defaults
Format or Range
Y or N
1 1 4 7
The signaling configuration parameters are reset to
their factory default values.
Signaling Configuration was set to
defaults.
to cancel.