Setup Procedure Sections; Entering Data; Navigation Aids; Integrated Fast Setup Operation - 3Com CoreBuilder 9000 User Manual

46 C 3: I
HAPTER NTEGRATED
Setup Procedure
Sections

Entering Data

Navigation Aids

Integrated Fast Setup
Operation
F S
AST ETUP
Table 6 lists the steps or sections of the Integrated Fast Setup.
Table 6 Integrated Fast Setup Procedure Sections
Setup Section
1 Network Prefix
2 LE Parameters
3 LECS Address
4 UNI/NNI parameters
5 IP and Management
Configuration
6 Confirmation
The Integrated Fast Setup procedure runs sequentially through the
relevant data for all of the sections, displaying a prompt for each data
item and a default value. If you want to change the default, enter a
different value in place of the default. If you want to accept the default,
press Enter.
Table 7 lists the shortcut characters that you can use to move between
sections of the Integrated Fast Setup procedure:
Table 7 Integrated Fast Setup Procedure Navigation Aids
Type To Go
< Back to previous section
> To next section
>S To section indicated by double underlined ID letter S in section title
\ Back to beginning of setup
$ To end of setup
For step-by-step instructions, see the CoreBuilder 9000 ATM Switch
Fabric Module Getting Started Guide.
Description
Set Network Prefix for the CoreBuilder 9000 ATM
Enterprise Switch
Set LE parameters for the CoreBuilder 9000 ATM
Enterprise Switch
Set active LECS address for the CoreBuilder 9000 ATM
Enterprise Switch
Set UNI/NNI port parameters for ports in the ATM
Interface Module
Set IP address of the switch, address of the NMS
application, default gateway address, and subnet mask
Confirm setup operation