Update Protocol Timer Resolution - 3Com CoreBuilder 9000 User Manual

Update Protocol
Timer Resolution
Update the timer resolution of the CoreBuilder 9000 ATM Enterprise
Switch. The default timer resolution is 500 msec (0.5 secs); the minimum
timer resolution is 100 msec and there is no upper limit. For more
information, see the previous section and see "Timer Resolution" on
page 363.
This command causes the new timer resolution to be activated in the
current session. The new value is stored in flash.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Parameter
Timer Resolution
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 1 2 250
The following message appears:
Timer resolution was successfully set.
The timer resolution is updated to 250 msec and saved to flash.
(1) SET: Switch setup
(4) SIG: Signaling setup
(1) RES: Timer Resolution setup
(2) SET: Set Timer Resolution
Format or Range
in millisec; Range: >=100
1 1 4 1 2 [parameters]
The timer resolution is updated.
Timer resolution was successfully set.
Signaling Timers 199