100
C
5: C
HAPTER
ONFIGURING THE
Upgrade Software
Files
P
LATFORM
Upgrade the software on the standby switch fabric module from the
active switch fabric module. After upgrading, the standby switch fabric
module must be reset. See "Reset Standby Switch Fabric Module" on
page 98 for details on how to reset the standby switch fabric module.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 4 3 3
The following prompt is displayed:
Upgrade software files!
Are you sure (Y/N)? y
The following messages are displayed:
The upgrading process will start shortly and take about 5
minutes.
The upgraded files will be active only after Stand-by SWM
reset.
(4) SWM: Switch modules
(3) SSM: Stand-by Switch Module
(3) SSU: Stand-by Software Upgrade
(1) USF: Upgrade Software Files
1 4 3 3 1
The software on the standby switch fabric module is
updated.
The upgrading process will start
shortly and take about 5 minutes.
The upgraded files will be active only
after Stand-by SWM reset.