Update Call-Proceeding Enable Value - 3Com CoreBuilder 9000 User Manual

Update Update the signaling call-proceeding enable flag and save it to flash
Call-Proceeding
memory. See the previous section for more details.
Enable Value
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message appears:
Call proceeding flag was successfully set to ON.
The call-proceeding enable flag is updated to on and saved to flash.
Parameter
Call-proceeding message
enable/disable value
1 1 4 6 2 1
(1) SET: Switch setup
(4) SIG: Signaling setup
(6) CCL: Signaling call control
setup
(2) SET: Set call proceeding value
Format or Range
0 to suppress call-proceeding messages (off)
1 to send call-proceeding messages (on)
1 1 4 6 2 [parameters]
The call-proceeding enable flag is updated.
Call proceeding flag was successfully
set to: <ON/OFF>
Signaling Setup 195