Reset Network Prefix Configuration - 3Com CoreBuilder 9000 User Manual

Reset Network Prefix
Configuration
Reset the network prefix configuration parameters for the
CoreBuilder 9000 ATM Enterprise Switch to their factory default settings.
The default setting is 47.00.00.00.00.00.3c.00.60.9*.
The reset takes place after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 6 3
The following prompt is displayed:
Do you really want to reset config [y/n]?
Enter to confirm. The following message is displayed:
y
Network prefix configuration was set to defaults.
The network prefix configuration parameters are reset to their factory
values.
(1) SET: Switch Setup
(6) SNP: Switch Network Prefix Setup
(3) RNP: Set Network Prefix to
Factory Defaults
1 1 6 3
The network prefix configuration parameters are reset
to their factory default values.
Network prefix configuration was set to
defaults.
Network Prefix 151