Add Elan; Ane: Add New Elan Record - 3Com CoreBuilder 9000 User Manual

256 C 9: M
HAPTER ANAGING

Add ELAN

LAN E
MULATION
Add an ELAN to the LECS database, that is, add a new LES. Specify the
ELAN name and LES ATM address.
You can use any legal ELAN name. The names of the ELANs on a
particular switch all have the form elan_<XXXX>_<n> where <XXXX> is
a number unique to the switch and <n> is the sequential number of the
ELAN between 0 and 15. This is the form to use for ELANs that you enter
in this section.
If the requested LES ATM address already exists in the LECS database, this
command defines a new alias ELAN with the same LAN type and frame
size. If the LES ATM address does not match any ATM address in the LECS
database, a new ELAN is created with the LAN type and max frame size
set to the default values (Ethernet, 1516).
You can define up to 380 ELANs in the LECS database of a
CoreBuilder 9000 ATM Enterprise Switch. Each CoreBuilder 9000 ATM
Enterprise Switch LECS database has 16 default ELAN names and default
ATM addresses corresponding to the LESs in the same switch.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
ELAN name
ATM Address
Direct access sequence:
Command Result
System action taken:
System message display:
(2) LEM: LAN Emulation
(1) LCS: LE Configuration Services
(5) LNT: LECS Network topology

(6) ANE: Add new ELAN record

Format or Range
Up to 32 characters. (For more information, see
"Display ELANs" on page 245.)
20 Hex bytes separated by dots
2 1 5 6 [parameters]
The specified ELAN is added to the LECS database.
New elan was added.