Update Elan Parameters In Les Database; Eln: Elans Info (1) Lsu: Les Setup (1) Adr: Set & Save Les-Bus Address - 3Com CoreBuilder 9000 User Manual

Update ELAN
Parameters in LES
Database
Update the parameters for the specified ELAN in the LES database.
Table 36 describes the ELAN parameters you can update.
CAUTION: After you use this command to update the parameters of an
ELAN in the LES database, you must use the LMA to update the
parameters of the ELAN in the LECS database in exactly the same way.
(For more information, see "Update ELAN Parameters in LECS Database"
on page 249.)
After updating the parameters, the ELAN is reset, that is, the control
distribute channel to all LECs that are attached to the ELAN is
disconnected.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
ELAN ID
ELAN type
Elan max frame size
Direct access sequence:
Command Result
System action taken:
System message display:
(2) LEM: LAN Emulation
(2) LES: LE Services
(4) EFP: LES Edit ELANs Parameters
Format or Range
1–16
For more information, see "Display ELAN Parameters in
LES Database" on page 278.
1-Ethernet
2-Token ring
3-VLT
1-1516
2-4544
2 2 4 [parameters]
The parameters for the specified ELAN are updated.
The update takes place immediately.
ELAN is reset.
ELAN Parameters 281