Update Auto-Configuration Status - 3Com CoreBuilder 9000 User Manual

Update
Auto-configuration
Status
Update the Auto-configuration Status for the specified port in the
CoreBuilder 9000 ATM Enterprise Switch. Enable the Auto-configuration
Status only if both ATM Switch Fabric Modules have an
auto-configuration capability.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port ID
Auto-configuration
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 2 2 3.1.2
The following message is displayed:
Auto-Configuration is set to ENABLED.
The auto-configuration status of port 3.1.2 is enabled.
(1) SET: Switch Setup
(8) IME: ILMI Setup
(2) AUC: Auto-Configuration Setup
(2) SET: Set Auto-Configuration
ON/OFF Status
Format or Range
<slot.group.port>
0 to disable auto-configuration
1 to enable auto-configuration
1 1 8 2 2 [parameters]
The Auto-configuration Status is updated for the
selected port.
Auto-Configuration is set to
<ENABLED/DISABLED>.
1
ILMI Setup 125