Set Loop Mode; Slm: Set Loop Mode - 3Com CoreBuilder 9000 User Manual

108 C 5: C
HAPTER ONFIGURING THE

Set Loop Mode

P
LATFORM
Set the loop mode of selected port as None, Loop Forward, or Loop Back.
You are prompted to specify a port and a mode.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port Number
Loop Mode
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter
1 5 5 1.1.2 1
The following message is displayed:
Setting loop mode has completed successfully.
The loop mode of port 1.1.2 is set to loop back.
(5) IFC: Interface Cards

(5) SLM: Set Loop Mode

Format or Range
<slot.group.port> (0.0 - For all)
0 for No loop
1 for Loop back
2 for Loop forward
1 5 5 [parameters]
The loop mode of the selected port on the interface
module is set and saved.
Setting loop mode has completed
successfully.