Direct Access To Submenus - 3Com CoreBuilder 9000 User Manual

52
C 4: U
HAPTER SING THE
Direct Access to
Submenus
L M A
OCAL ANAGEMENT PPLICATION
The Password Setup Menu is displayed as follows, followed by the path
(1)SYS\(1)SET\(1)PAS
configuration commands; none of them have arrows to the right.
CB9000 switch module - Password Setup Menu:
(1) REA: Set Read-access Password
(2) WRI: Set Write-access Password
(3) ADM: Set Admin-access Password
(4) PAS: Set Password Config to factory defaults
[ '\' -Main,
(1)SYS\(1)SET\(1)PAS>1
4 At the Password Setup Menu prompt, enter
The prompt for the new read password is displayed as follows:
Enter the new read password:
This completes the menu sequence.
Entering the Command Parameters
Now refer to section B in . This section explains which parameters to
enter and the format to use.
5 At the
Enter the new read password:
password in a format of up to eight alphanumeric characters.
6 At the
Enter the new read password again:
password again exactly as before.
Command Results
After the command executes successfully, a system message is displayed:
The password has been changed.
The command results and systems messages are shown in section D in .
You can display a submenu or execute a command directly without
having to step down through the hierarchy as in the previous example. At
the Main Menu prompt, type the required sequence of menu item
numbers or menu item mnemonic followed by the command parameters
all on one line, separated by spacebar strokes. For example, to display the
password prompt directly from the Main Menu, just enter
Main Menu prompt.
and the ( ) prompt. These menu items are all
>
'-' -Back in menus]
prompt, enter the new
1.
prompt, enter the new
1 1 1 1
at the