Display Call-Proceeding Enable Value - 3Com CoreBuilder 9000 User Manual

194 C 7: C
HAPTER ONFIGURING
Display
Call-Proceeding
Enable Value
V C
IRTUAL HANNELS
Display the value of the call-proceeding enable value.
With the call-proceeding enable value, the user can suppress the
message that is returned to the edge device or end
call-proceeding
user that has sent a signaling SETUP message. For more information, see
"CALL PROCEEDING Message" on page 357.
When the call-proceeding value is ON, the call-proceeding message is
sent. When the call-proceeding value is OFF, the call-proceeding message
is suppressed.
Command Actions
Enter the menu sequence: (1) SYS: Platform configuration
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 6 1
The following message is displayed:
Call proceeding value is ON.
(1) SET: Switch setup
(4) SIG: Signaling setup
(6) CCL: Signaling call control
setup
(1) GET: Get call proceeding value
1 1 4 6 1
The call-proceeding enable flag is displayed.
Call proceeding value is <ON/OFF>.