Update Port Network Connection Type - 3Com CoreBuilder 9000 User Manual

84 C 5: C
HAPTER ONFIGURING THE
Update Port Network
Connection Type
P
LATFORM
Update the network connection type (NNI, UNI, or GWY) for a specified
port of the CoreBuilder 9000 ATM Enterprise Switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port number
NNI interface type
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 3 4 3.1.2 1
The following message is displayed:
This operation will release all SVC connections of the
specified port(s)!
Are you sure (Y/N)?
Enter y to confirm. The following message is displayed:
UNI type was set.
The network connection type for port 3.1.2 is updated to UNI.
(1) SET: Switch Setup
(3) NNI: NNI Setup
(4) SIF: NNI Set Interface Type
Format or Range
slot.group.port (0.0 for all ports)
0 to set network connection type to NNI
1 to set network connection type to UNI
2 to set network connection type to GWY
1 1 3 4 [parameters]
The network connection type for the specified port is
updated.
<NNI>/<UNI>/<GWY> type was set.