Atm Addresses Port Table; Display User Management Entities (Ume) Atm Addresses At Port - 3Com CoreBuilder 9000 User Manual

132 C 6: M
HAPTER ANAGING
ATM Addresses Port
Table
Display User
Management Entities
(UME) ATM
Addresses at Port
N I
ETWORK NTERFACES
You can configure the ATM addresses as follows:

Display User Management Entities (UME) ATM Addresses at Port

Display Static ATM Addresses at Port


Display De-registered ATM Addresses at Port


Delete All ATM Addresses at Port


Add ATM Address to Port


Delete ATM Address by Member ID


Get ATM Addresses at Port


Delete All Active Addresses
Display User Management Entities (UME) registered ATM addresses for
specified ports of the CoreBuilder 9000 ATM Enterprise Switch. These
ATM addresses were received from end stations or edge devices attached
to the port and registered using ILMI in the MIB address table. (For more
information, see "UNI Address Registration" on page 325.)
Addresses defined through LMA are not displayed.
For easy reference, each ATM address registered at a port is assigned a
member ID. The member ID is made up of the port number followed by a
two-digit number of the form 0n, where 0 corresponds to the 1
address registered. For example, the member ID for the first ATM address
registered at port 3.1.3 is 31301.
The member ID is useful for displaying information about calls that are
associated with the ATM address. For example, the switched virtual
channels (SVC) are established to the LEC, whose ATM address is
registered at the port. You can use the member ID to get information for
the specific port attached to that ATM address.
st ATM