Reset Saved-Configuration - 3Com 8807 Command Reference Manual

reset
saved-configuration
the system software actually used for the current enabling, the filename of the
system software configured for the next enabling, the configuration filename used
for the current enabling, the configuration filename configured for the next
enabling.
Related command: startup saved-configuration.
Example
# Display the filenames related to the current and the next enabling.
<SW8800> display startup
MainBoard:
Startup saved-configuration file:
Next startup saved-configuration file:
Syntax

reset saved-configuration

View
User view
Parameter
None
Description
Use the reset saved-configuration command to erase configuration files from
the flash memory of the switch.
Perform this command with cautious. It is suggested to consult technical support
personnel first.
Generally, this command is used in the following situations:
After upgrade of software, configuration files in flash memory may not match
■
the new version's software. Perform the reset saved-configuration command
to erase the old configuration files.
If a used switch is applied to the new circumstance and the original
■
configuration files cannot meet the new requirements, the switch should be
configured again. Erase the original configuration files for reconfiguration.
If the configuration files do not exist in the flash memory when the switch is
electrified and initialized, it will enter setup switch view automatically.
Related command: save, display current-configuration, display
saved-configuration.
Example
# Erase the configuration files from the flash memory of the switch.
<SW8800> reset saved-configuration
The saved configuration will be erased.
Are you sure?[Y/N]
Configuration File Management Commands
flash:/8500.cfg
flash:/8500.cfg
73