Set Clock Source To Internal; Rst: Set Clock Source To Internal - 3Com CoreBuilder 9000 User Manual

120 C 5: C
HAPTER ONFIGURING THE
Set Clock Source to
Internal
P
LATFORM
Example
Enter:
1 8 3 5.1.2
The following prompt is displayed:
This operation will change the active clock source.
Do you really want to change it (Y/N)? Y
The following message is displayed:
External clock source port 2 was successfully configured to
port <5.1.2>.
Reset the clock source configuration to its default values.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action:
System message display:
Example
Enter:
1 8 4
The following prompt is displayed:
Do you really want to reset config? [y/n] y
The following message is displayed:
Clock Source configuration was set to default.
(1) SYS: Platform Configuration
(8) SCS: Switch Clock Synchronization
Setup

(4) RST: Set Clock Source to Internal

1 8 4
The clock source configuration is reset to its default
values.
Clock Source configuration was set to
default.