Table 10.30 Pwm Output Registers And Output Pins - Hitachi H8S/2628 Hardware Manual

There are two PWM modes, as described below.
• PWM mode 1
PWM output is generated from the TIOCA and TIOCC pins by pairing TGRA with TGRB and
TGRC with TGRD. The output specified by bits IOA0 to IOA3 and IOC0 to IOC3 in TIOR is
output from the TIOCA and TIOCC pins at compare matches A and C, and the output
specified by bits IOB0 to IOB3 and IOD0 to IOD3 in TIOR is output at compare matches B
and D. The initial output value is the value set in TGRA or TGRC. If the set values of paired
TGRs are identical, the output value does not change when a compare match occurs.
In PWM mode 1, a maximum 8-phase PWM output is possible.
• PWM mode 2
PWM output is generated using one TGR as the cycle register and the others as duty cycle
registers. The output specified in TIOR is performed by means of compare matches. Upon
counter clearing by a synchronization register compare match, the output value of each pin is
the initial value set in TIOR. If the set values of the cycle and duty cycle registers are identical,
the output value does not change when a compare match occurs.
In PWM mode 2, a maximum 15-phase PWM output is possible in combination use with
synchronous operation.
The correspondence between PWM output pins and registers is shown in table 10.30.

Table 10.30 PWM Output Registers and Output Pins

Channel
0
1
2
3
Rev. 1.0, 09/02, page 210 of 568
Registers
TGRA_0
TGRB_0
TGRC_0
TGRD_0
TGRA_1
TGRB_1
TGRA_2
TGRB_2
TGRA_3
TGRB_3
TGRC_3
TGRD_3
Output Pins
PWM Mode 1
TIOCA0
TIOCC0
TIOCA1
TIOCA2
TIOCA3
TIOCC3
PWM Mode 2
TIOCA0
TIOCB0
TIOCC0
TIOCD0
TIOCA1
TIOCB1
TIOCA2
TIOCB2
TIOCA3
TIOCB3
TIOCC3
TIOCD3