Simultaneous Serial Data Transmission And Reception (Clocked Synchronous Mode) - Hitachi H8S/2628 Hardware Manual

14.6.5 Simultaneous Serial Data Transmission and Reception (Clocked Synchronous
Mode)
Figure 14.20 shows a sample flowchart for simultaneous serial transmit and receive operations.
The following procedure should be used for simultaneous serial data transmit and receive
operations after initializing the SCI. To switch from transmit mode to simultaneous transmit and
receive mode, after checking that the SCI has finished transmission and the TDRE and TEND
flags are set to 1, clear TE to 0. Then simultaneously set TE and RE to 1 with a single instruction.
To switch from receive mode to simultaneous transmit and receive mode, after checking that the
SCI has finished reception, clear RE to 0. Then after checking that the RDRF and receive error
flags (ORER, FER, and PER) are cleared to 0, simultaneously set TE and RE to 1 with a single
instruction.
Rev. 1.0, 09/02, page 338 of 568