Figure 2-5 Networking Diagram For Configuring Static Routes - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
GRE is used between S9300-A and S9300-C to implement the interworking between PC1 and
PC2.
PC1 and PC2 use S9300-A and S9300-C as their default gateways.

Figure 2-5 Networking diagram for configuring static routes

S9300-A
S9300
S9300-A
S9300-B
S9300-C
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Issue 01 (2009-07-28)
S9300-B
GE1/0/0
GE1/0/0
Tunnel7/0/0
GE2/0/0
40.1.1.1/24
PC1
10.1.1.1/24
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
GigabitEthernet1/0/0
GigabitEthernet2/0/0
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Run the dynamic routing protocol on the S9300s to implement interconnection.
Create tunnel interfaces on S9300-A and S9300-C and specify the source and destination
addresses of the tunnel. The source address is the IP address of the interface sending packets,
and the destination address is the IP address of the interface receiving packets.
Configure the IP address of the tunnel so that the tunnel supports the dynamic routing
protocol.
Configure the static route between S9300-A and its connected PCs, and between S9300-C
and its connected PCs to make the traffic between PC1 and PC2 transmitted through the
GRE tunnel.
Configure the egress of the static route as the local tunnel interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE2/0/0
GE1/0/0
S9300-C
Tunnel7/0/0
GE2/0/0
40.1.1.2/24
PC2
10.2.1.1/24
VLANIF interface
VLANIF 10
VLANIF 30
VLANIF 10
VLANIF 20
VLANIF 20
VLANIF 40
2 GRE Configuration
IP address
20.1.1.1/24
10.1.1.2/24
20.1.1.2/24
30.1.1.1/24
30.1.1.2/24
10.2.1.2/24
2-15