Enabling The Layer 2 Circuit When The Mtu Does Not Match; Enabling The Layer 2 Circuit When The Encapsulation Does Not Match - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Enabling the Layer 2 Circuit When the MTU Does Not Match

Related
Documentation

Enabling the Layer 2 Circuit When the Encapsulation Does Not Match

780
You can include this statement at the following hierarchy levels:
[edit protocols l2circuit neighbor address interface interface-name]
By default, the PSN tunnel endpoint for a Layer 2 circuit is identical to the neighbor
address, which is also the same as the LDP neighbor address.
The tunnel endpoints on the remote router do not need to be loopback addresses.
The following example illustrates how you might configure a PSN tunnel endpoint:
[edit protocols l2circuit]
neighbor 10.255.0.6 {
interface t1-0/2/2.0 {
psn-tunnel-endpoint 20.20.20.20;
virtual-circuit-id 1;
}
interface t1-0/2/1.0 {
virtual-circuit-id 10;
}
}
The Layer 2 circuit configured for the
table to . This could be either an RSVP route or a static route with an LSP
20.20.20.20
next hop.
Configuring Logical Units on the Loopback Interface for Routing Instances in Layer 3 VPNs
You can configure the Junos OS to allow a Layer 2 circuit to be established even though
the MTU configured on the PE router does not match the MTU configured on the remote
PE router by including the ignore-mtu-mismatch
neighbor address interface interface-name]
Configuring the MTU Advertised for a Layer 2 Circuit on page 777
Configuring the Media MTU
You can configure the Junos OS to allow a Layer 2 circuit to be established even though
the encapsulation configured on the CE device interface does not match the encapsulation
configured on the Layer 2 circuit interface by including the
statement. You can configure the
connection to the remote connection by including the statement at the
l2circuit neighbor address interface interface-name]
connection by including this statement at the
interface interface-name] hierarchy level.
ignore-encapsulation-mismatch;
interface resolves in the inet3 routing
t1-0/2/2.0
statement at the
hierarchy level.
ignore-encapsulation-mismatch
ignore-encapsulation-mismatch
hierarchy level or for the local
[edit protocols l2circuit local-switching
Copyright © 2017, Juniper Networks, Inc.
[edit protocols l2circuit
statement for the
[edit protocols