Configuring Load Balancing For Ethernet Pseudowires - Juniper ACX1000 Configuration Manual

Configuring Load Balancing for Ethernet Pseudowires

Copyright © 2017, Juniper Networks, Inc.
You can configure load balancing for IPv4 traffic over Layer 2 Ethernet pseudowires. You
can also configure load balancing for Ethernet pseudowires based on IP information. The
option to include IP information in the hash key provides support for Ethernet circuit
cross-connect (CCC) connections.
NOTE: This feature is supported only on M120, M320, MX Series, and T Series
routers.
To configure load balancing for IPv4 traffic over Layer 2 Ethernet pseudowires, include
the ether-pseudowire statement at the
hierarchy level:
payload]
[edit forwarding-options]
hash-key {
family mpls {
(label-1 | no-labels);
payload {
ether-pseudowire;
}
}
}
NOTE: You must also configure either the
at the
[edit forwarding-options hash-key family mpls]
You can also configure load balancing for Ethernet pseudowires based on IP information.
This functionality provides support for load balancing for Ethernet cross-circuit connect
(CCC) connections. To include IP information in the hash key, include the
at the [edit forwarding-options hash-key family mpls payload]
[edit forwarding-options]
hash-key {
family mpls {
(label-1 | no-labels);
payload {
ip;
}
}
}
NOTE: You must also configure either the
the
[edit forwarding-options hash-key family mpls]
You can configure load balancing for IPv4 traffic over Ethernet pseudowires to include
only Layer 3 IP information in the hash key. To include only Layer 3 IP information, include
Chapter 25: Configuring Layer 2 and Layer 3 Services
[edit forwarding-options hash-key family mpls
or the
label-1
hierarchy level.
hierarchy level:
label-1 or no-labels
hierarchy level.
statement
no-labels
statement
ip
statement at
797