Configuring Mac Address Limits On A Logical Interface - Juniper ACX1000 Configuration Manual

Related
Documentation

Configuring MAC Address Limits on a Logical Interface

Copyright © 2017, Juniper Networks, Inc.
To modify the size of the MAC table, include the
[edit bridge-domains bridge-domain-name bridge-options]
[edit]
bridge-domains {
bridge-domain-name {
bridge-options {
mac-table-size limit {
packet-action drop;
}
}
}
}
NOTE: The mac-table-size
ACX5096 routers.
Layer 2 Bridge Domains on ACX Series Overview on page 755
Q-in-Q Tunneling on ACX Series Overview on page 770
Layer 2 Learning and Forwarding for Bridge Domains Overview on page 759
Configuring a Bridge Domain on ACX Series Routers on page 760
Configuring Q-in-Q Tunneling on ACX Series on page 771
Configuring VLAN Identifiers for Bridge Domains in ACX Series on page 764
Disabling MAC Learning for Bridge Domains on ACX Series on page 765
Configuring Static MAC Addresses for Logical Interfaces in a Bridge Domain in ACX
Series on page 766
You can configure a limit on the number of MAC addresses learned from a specific logical
interface. This feature allows the MAC address table space to be distributed among
different logical interfaces thereby avoiding congestion. The MAC address limit can be
applied for both VLAN and VPLS routing instances and by default the MAC limit depends
on the profile configured. You can limit MAC addresses for a bridge domain and a logical
interface at the same time.
NOTE: MAC limiting is supported only on ACX5000 Series routers.
Configuring MAC Address limit on page 768
Configuring MAC Address Limits for VLANs on page 768
Configuring MAC Address Limits for VPLS on page 768
CLI Commands to Configure MAC Address Limits on page 769
Chapter 24: Configuring Layer 2 Bridging and Q-in-Q Tunneling
mac-table-size limit
hierarchy level:
CLI statement is not supported on ACX5048 and
statement at the
767