Replacing A T1600-Sib; Removing A T1600-Sib - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
Related
Documentation

Replacing a T1600-SIB

Removing a T1600-SIB

230
Figure 131: Installing an SCG
Maintaining the T1600 SCGs on page 156
T1600 SONET Clock Generators (SCGs) Description on page 50
Removing a T1600-SIB on page 230
Installing a T1600-SIB on page 231
Verifying the Installation of a T1600-SIB on page 232
Five SIBs are installed in the router. The SIBs are located in the rear of the chassis in the
slots marked through
SIB0
To remove the SIBs (see Figure 132 on page 231):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
3.
handles on each side of the SIB faceplate.
Flip the ejector handles outward to unseat the SIB.
4.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
5.
way out of the chassis.
Place one hand underneath the SIB to support it and slide it completely out of the
6.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
. Each T1600-SIB weighs approximately 6.5 lb (3 kg).
SIB4
Copyright © 2010, Juniper Networks, Inc.