Configuration Of Store To Folder; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Scanner Environment Settings

Configuration of Store to Folder

This section describes configuration procedures to use the Store to Folder service on the
machine.

Step 1 Enabling Port and Setting up TCP/IP

Using Network Scanner Utility 3 (Scan Driver and Stored File Manager 3), which supports
WebDAV protocol, and Device Setup Tool, enable the SNMP, SOAP, and WebDAV ports and
set up an IP address.
Important
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
9
2
Enable the ports.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [SOAP], and then select [Change Settings].
8) Select [Port Status], and then select [Change Settings].
9) Select [Enabled], and then select [Save].
10)Select [Close].
11)Select [WebDAV], and then select [Change Settings].
12)Select [Port Status], and then select [Change Settings].
400
We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when you use
WebDAV. This is an effectual way to avoid password leaking.
You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "CentreWare Internet Services Settings" (P.365).
displayed on the screen, and select [Enter].
The default user ID is "11111".
The default passcode is "x-admin".