Changing The Paper Size For Tray 3 (When Tandem Tray Module Is Installed) - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

4
Load and align the edge of the paper against the left side of the tray, with the side to be
copied or printed on facing up.
Important
Do not load paper above the maximum fill line ("MAX" in the right figure).
5
Push the tray in gently until it stops.
Important
When inserting the tray, push it gently. Forcibly pushing the tray in may cause machine malfunction.
Note
Affix the paper size label to the front of the paper tray.
Reference
For more information on paper type settings, refer to "Changing the Paper Settings" (P.73).
Changing the Paper Size for Tray 3 (When Tandem Tray Module is
Installed)
The following describes how to change paper size in Tray 3 when the Tandem Tray Module
is installed.
1
Pull out Tray 3 until it stops.
CAUTION
Make sure to pull out the tray slowly. When the tray is being pulled out
with force, the tray may possibly hit your knees or other parts of your
body causing injuries.
Important
While the machine is processing a job, do not pull out the tray that is being used for the job.
To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add paper on
top of any remaining paper in the tray.
Changing the Paper Size
67
2