Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 654

Problem Solving
15
654
Error Code
116-387 [Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
116-388 [Cause] The optional hard disk is not installed.
[Remedy] Install the hard disk. Contact our Customer Support Center.
116-389 [Cause] The Extension System Memory is not installed.
[Remedy] Install the Extension System Memory. Contact our Customer
Support Center.
116-390 [Cause] An error occurred in the machine.
[Remedy] Follow the message displayed on the touch screen and initialize
the memory of the machine.
116-391 [Cause] An error occurred in the machine.
116-392
[Remedy] Switch off the machine power, make sure that the touch screen
116-393
is blank, and then switch on the machine power. If the same
116-394
message is displayed again, contact our Customer Support
Center.
116-395
116-396
116-397
116-399
116-701 [Cause]
Unable to use the 2 Sided Printing feature because of
insufficient memory.
[Remedy] Increase memory, or install the hard disk if it is not installed.
116-702
[Cause] A print job was processed using a substitute font.
[Remedy] Check the print data.
116-703 [Cause] Probable causes are as follows:
1) An error occurred during PostScript (optional) processing.
2) An error occurred because of insufficient memory.
3) An error occurred because of insufficient memory for
[Remedy] For 1), check the print data.
For 2), increase memory.
For 3), increase the value for [PostScript Memory].
116-704
[Cause] An error occurred when reading data on the media.
[Remedy] Check whether the media is inserted correctly.
116-705 [Cause] An error occurred when reading data on the media.
116-706
[Remedy] Use a computer to confirm the content recorded on the media.
116-707
116-708
116-709
116-710 [Cause] The correct document size could not be judged because the
receive data exceeded the HP-GL/2 spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout memory.
Cause and Remedy
PostScript processing.