Replacing Booklet Staple Cartridge (For C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Maintenance

Replacing Booklet Staple Cartridge (for C3 Finisher with Booklet Maker)

When the C3 Finisher with Booklet Maker (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
The Booklet Staple cartridge [R2] is running out
of staples. Please order a Booklet Staple
Cartridge [R2].
The Booklet Staple Cartridge [R2] is out of
staples or not fully inserted. Check the Staple
Cartridge [R2].
* : The messages above are for the Booklet Staple Cartridge [R2]. For the Booklet Staple Cartridge [R3], [R3] is displayed.
Important
3
Note
1
Make sure that the machine is not operating, and open the finisher front door.
2
Pull out the booklet unit.
98
Message
The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only booklet staple cartridges recommended by Fuji Xerox.
When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Server> button
and the <Machine Status> button on the control panel before you replace the staple cartridge.
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
If the booklet staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the booklet staple cartridge again.
To order a booklet staple cartridge, contact our Customer Support Center.
Solution
Prepare new staples.
Note
Staples cannot be replaced yet.
Replace staples with new ones.