Installation When Using Usb Port; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Installation When Using USB Port

This section describes how to install the machine using a USB interface.

Step 1 Preparations

The following items are required to connect the machine to a computer via a USB interface.
USB cable
Media (Software/Product Manual) provided with the machine

Step 2 Configuration on the Machine

The following describes the configuration procedures to use a USB interface on the
machine.
Note
To print binary data using a USB interface, set [Adobe Communication Protocol] to [RAW]. For more
information, refer to "USB" (P.233).
You can configure the settings using CentreWare Internet Services. For items that can be configured using
CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items" (P.378).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note
The default user ID is "11111".
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2
Enable the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Configure [Print Mode] or [Auto Eject Time] as necessary.
Reference
For information on the setting items, refer to "USB" (P.233).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
Installation When Using USB Port
7
377