Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 815

Basic Settings
Parameter Item No.
Document size
Paper size
101 Sets the document size created by a computer.
[0]: ] A0
[1]: A1
[2]: A2
[3]: A3
[4]: A4
[5]: A5
[10]: B0
[11]: B1
[12]: B2
[13]: B3
[14]: B4
[15]: B5
[99] (Default): Auto
[100]: Paper
When [Auto] is selected, the settings of the Scaling mode, the Area
Determination mode, and the Paper Margin settings of Print Control become
enabled.
Note
If the document size other than [Auto] is selected, the settings under [Auto layout]
become [ON].
Depending on the combination of [Document size] and [Paper size], the document
is printed at a scale of 100%.
102 Sets the default paper size. Only available when [Paper tray] is set to [Auto] or
[Tray 5]. Only cut sheet can be set.
[3]: A3
[4]: A4
[5]: A5
[14]: B4
[15]: B5
[99]: Auto
[101] (Default): A Size
Important
When Trays 1 to 4, Tray 6 is selected, [Paper size] cannot be set. The paper size
loaded in the specified tray is displayed.
Note
If [A Size] or [Auto] is selected, the settings become as follows:
When [Document size] is set to other than [Auto], [Paper size] is set to [A3].
When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the size of
paper loaded in the tray, and thus [Paper size] cannot be set.
Depending on the combination of [Document size] and [Paper size], [?] may be
displayed for the magnification. In this case, the document is printed at a scale of
100%.
HP-GL/2 Emulation
Value
16
815