Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 659

Error Code
121-314 [Cause] An error occurred between the machine and the device
connected.
121-316
121-317
[Remedy] Switch off the machine power, make sure that the touch screen
121-318 is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
121-319
Center.
121-322
121-323
121-324
121-325 [Cause] The machine detects unacceptable combination.
The unacceptable combination are as follows:
[Remedy] Take one of the following measures:
121-326 [Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
121-327 [Cause] The machine does not support the connected product.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
121-339
[Cause] An error occurred between the machine and the device
connected.
[Remedy] Check the unit table for CoinKit. If an undefined item is included
in the table, correct the table. Switch off the machine power,
make sure that the touch screen is blank, and then switch on the
machine power. If the error still is not resolved, contact our
Customer Support Center.
121-340 [Cause] An error occurred between the machine and the device
connected.
121-350
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
Cause and Remedy
Both the USB IC card reader and the EP related equipment
are used
[Login to Local Accounts] is set to [Login Type]
[Smart Card or Control Panel Login] is set to [When Smart
Card Reader is Connected]
When both Smart Card and Control Panel Login are not used,
the setting of [When Smart Card Reader is Connected] will be
automatically changed to [Smart Card Login]. No measure is
required.
When only the USB IC card reader is connected to the
machine and both Smart Card and Control Panel Login are
used, contact our Customer Support Center.
Error Code
15
659