Configuration Of Store To Folder; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-V 4020 Administrator's Manual

9 Scanner Environment Settings

Configuration of Store to Folder

This section describes configuration procedures to use the Store to Folder service on the
machine.
The following shows the reference section for each procedure.

Step 1 Enabling Port and Setting up TCP/IP......................................................................................................................... 286

Step 2 Registering a Folder ....................................................................................................................................................... 287
Step 3 Configuring on the Computer...................................................................................................................................... 287
Step 1 Enabling Port and Setting up TCP/IP
Using Network Scanner Utility 3 (Scan Driver and Stored File Manager 3), which supports
WebDAV protocol, and Device Setup Tool, enable the SNMP,SOAP, and WebDAV ports and
set up an IP address.
Important • We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
9
3) Select [Tools] on the Services Home screen.
2
Enable the ports.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [SOAP], and then select [Change Settings].
8) Select [Port Status], and then select [Change Settings].
9) Select [Enabled], and then select [Save].
10) Select [Close].
11) Select [WebDAV], and then select [Change Settings].
12) Select [Port Status], and then select [Change Settings].
13) Select [Enabled], and then select [Save].
14) Select [Close] repeatedly until the [Tools] screen is displayed.
286
you use WebDAV. This is an effectual way to avoid password leaking.
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.261).
• The default user ID is "11111".
• The default passcode is "x-admin".