Outgoing/Incoming E-Mail Settings - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Tools
UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important
TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important
RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important
Prioritize IP Packets / Prioritize IP Packets (Ethernet 1), Prioritize IP Packets (Ethernet 2)
Set the priority of IP packet transmission from 0 to 255.
Note
5

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
Server Name/IP Address
Enter a server name or IP address with up to 256 characters, and then select [Save].
Note
Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important
250
Do not use any numbers assigned to other ports.
Do not use any numbers assigned to other ports.
Do not use any numbers assigned to other ports.
The value set varies depending on your environment. Consult your network administrator.
Set the value already specified by the network side. If you set other values, the priority does not change.
®
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult your network
administrator.)
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [Prioritize IP Packets] is displayed. When two Ethernet interfaces are used, [Prioritize IP
Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] are displayed.
When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network Name], the
specified names are displayed instead of "Ethernet1" and "Ethernet2" of [Prioritize IP Packets (Ethernet 1)]
and [Prioritize IP Packets (Ethernet 2)] respectively.
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
Do not use the numbers assigned to the other ports.