Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 262

Tools
Note
Note
5
IEEE 802.1X Settings / IEEE 802.1X Settings (Ethernet 1), IEEE 802.1X Settings (Ethernet 2)
Note
IEEE 802.1x Settings
Configure the IEEE 802.1X settings.
262
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
The value must be greater than the value set in [IPsec SA Life Time].
IPsec SA Life Time
Specify IPsec SA lifetime from 300 to 172800 seconds in 1 second increments.
The value must be smaller than the value set in [IKE SA Life Time].
DH Group
Set DH group. Select from [G1] or [G2].
PFS Settings
Select whether or not to enable PFS.
Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.
Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.
Communicate with Non-IPsec Devices
Select whether or not to communicate with non-IPSec devices.
When both of the [TCP/IP - Network Settings (Ethernet 1)] setting and the [TCP/IP - Network Settings
(Ethernet 2)] setting are configured, you can configure individual IEEE802.1X settings for each Ethernet
interface.
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [IEEE 802.1X Settings] is displayed. When two Ethernet interfaces are used, [IEEE 802.1X
Settings (Ethernet 1)] and [IEEE 802.1X Settings (Ethernet 2)] are displayed.
When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network Name], the
specified names are displayed instead of "Ethernet1" and "Ethernet2" of [IEEE 802.1X Settings (Ethernet 1)]
and [IEEE 802.1X Settings (Ethernet 2)] respectively.
IEEE 802.1X
Set whether or not to use IEEE 802.1X authentication.
Authentication Method
Select from [EAP-MD5], [EAP-MS-CHAPv2], [PEAP/MS-CHAPv2], or [EAP-TLS].
Login User Name
Enter the login user name with up to 128 characters.
Login Password
Enter the login password with up to 128 characters.
Server Certificate Verification