Configuration Of Store To Folder; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

9 Scanner Environment Settings

Configuration of Store to Folder

This section describes configuration procedures to use the Store to Folder service on the
machine.

Step 1 Enabling Port and Setting up TCP/IP......................................................................................................................... 336

Step 2 Registering a Folder ....................................................................................................................................................... 337
Step 3 Configuring a Computer ............................................................................................................................................... 337
Step 1 Enabling Port and Setting up TCP/IP
Using Network Scanner Utility 3 (Scan Driver and Stored File Manager 3), which supports
WebDAV protocol, and Device Setup Tool, enable the SNMP, SOAP, and WebDAV ports and
set up an IP address.
Important • We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
9
2
Enable the ports.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [SOAP], and then select [Change Settings].
8) Select [Port Status], and then select [Change Settings].
9) Select [Enabled], and then select [Save].
10) Select [Close].
11) Select [WebDAV], and then select [Change Settings].
12) Select [Port Status], and then select [Change Settings].
13) Select [Enabled], and then select [Save].
14) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
336
you use WebDAV. This is an effectual way to avoid password leaking.
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.311).
• The default user ID is "11111".
• The default passcode is "x-admin".