Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 540

Problem Solving
"001-001" - "004-999"
15
540
Error Code
003-311
[Cause] An error occurred.
003-318
[Remedy] Switch off the machine power, make sure that the touch screen
003-319
is blank, and then switch on the machine power. If the same
003-320 message is displayed again, contact our Customer Support
Center.
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
003-700
[Cause] Too many documents are set in the document feeder after
clearing the paper jam.
[Remedy] Check the output, and then replace the documents that have
not been copied yet.
003-701 [Cause] A digital code is embedded in the document to restrict
duplication.
[Remedy] Use a document in which no digital code is embedded.
003-702
[Cause] You tried to copy sides 1 and 2 of a document simultaneously
specifying different Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703
[Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704 [Cause] An error is found in the calibration pattern read, and the
machine may be out of order.
[Remedy] Execute the calibration again. If the error is not still resolved,
contact our Customer Support Center.
Cause and Remedy