Pcl Emulation Settings - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Forcible Output in Emulation Mode
In emulation mode, data is not output until a complete page of data or a page-break
command is received. For a USB interface, if printing ends in the middle of a page, the next
data set waits until the time set with [Auto Eject Time] elapses.
In this case, the Forcible Printing feature does not wait for the auto eject time; however,
forcibly prints the data within the machine.
Reference
For more information on forcible printing, refer to "Job Status" in the User Guide.
For more information on the auto eject time, refer to "Auto Eject Time" (P.234).

PCL Emulation Settings

The following table shows the emulation parameters and their values for PCL emulation.
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter Item No.
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default): Auto
[1]: Tray 1
[2]: Tray 2
[3]: Tray 3
[4]: Tray 4
[5]: Tray 5
[6]: Tray 6 (HCF B1)
Important
When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper Size] cannot be set.
Note
When [Auto] is selected and paper of the same size in the same orientation in multiple
trays is loaded, paper will be fed in the order of Tray 1
Tray 6. If paper of the same size is loaded in multiple trays but in different
orientations, feeding of the paper loaded in the landscape orientation is prioritized.
Value
Tray 2
PCL Emulation
Tray 3 Tray 4
16
807