Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 251

Hide thumbs Also See for ApeosPort-VI C7771:

Table of Contents

Polling Interval

Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1

minute increments.

Enter the name to login to the POP3 server with up to 64 characters.

Enter a password for the POP3 server with up to 64 characters.

Enter the same password in [New Password] and [Retype Password] using the numeric

keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text

boxes blank and select [Save].

POP Password Encryption

Select [On (APOP)] to encrypt the password.

SMTP Server Settings

Setup the SMTP server.

You can check the connection between the machine and the SMTP server by sending a test

mail to the e-mail address specified in [Connection Test]. Selecting [Connection Test] >

[Print SMTP Comm. Report] outputs the report that shows the contents of protocol of the

SMTP communication transmitted and received by the machine.

SMTP Server Name/IP Address

Enter a server name or IP address, and then select[Save]. Up to 256 characters are allowed.

For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.

For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a

hexadecimal value.

SMTP Server Port Number

Enter a port number in the range from 1 to 65535.

The default value is 25.

Do not use the numbers assigned to the other ports.

E-mail Send Authentication

Select one from [Off], [POP before SMTP], or [SMTP AUTH].

If [POP before SMTP] is selected, the POP3 settings must be set.

AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or AUTH

CRAM-MD5 can be used as an authentication method.

Select the login user name when sending e-mails from [Remotely Authenticated User] and

When [Remotely Authenticated User] is selected and if the user has logged in to the remote

server before a job startup, the machine performs the SMTP server verification with the

remotely authenticated user name and password. You can also select the post-failure

behavior of the machine from [Cancel E-mail Send] and [Relogin using System Data]. If you

Connectivity & Network Setup