Fuji Xerox ApeosPort-VI C7771 Administrator's Manual page 617

Error Code
027-446 [Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the
machine, or the IP address of IPv6 on the network device, to
remove the duplication of addresses.
027-447
[Cause] The IP address of IPv6 network already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the
IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-452 [Cause] IP address of IPv4 already exists.
[Remedy] Change the IP address of IPv4 set on the machine or the IP
address of IPv4 on the network device.
027-500 [Cause]
Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the server by
using its IP address.
027-501 [Cause] A POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-502 [Cause] Failed to log into the POP3 server when using the POP3 protocol.
[Remedy] Confirm whether the user name and password used in the POP3
server are correct on CentreWare Internet Services.
027-503 [Cause] A POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-504 [Cause]
An SMTP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-513
[Cause] The machine failed to transfer data using SMB of the Scan to PC
service because access to the SMB server was not permitted.
When the server is Macintosh, a folder with the same name as
the specified file name may exist on the server.
[Remedy] Consult your system administrator for settings.
027-514 [Cause] The machine failed to transfer data using SMB of the Scan to PC
service because an error has been occurred between the SMB
server and the DNS server.
[Remedy] Check the following conditions:
027-515 [Cause] The machine failed to transfer data using SMB of the Scan to PC
service because an error has been occurred.
[Remedy] Take the following measures:
Cause and Remedy
The SMB server is connected to the DNS server.
The SMB server name is registered on the DNS server.
Set the DNS server address.
Set the target SMB server address using IP address.
Error Code
15
617