Using The Ethernet Interface - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Before Using the Machine
7
Return the rear right cover to its original position.
8
Connect the other end of the USB cable to the computer.
1
9
Press the main power switch to the [ | ] position to switch on the main power.
10
Close the front cover.
11
Press the push-button power switch to switch on the power.
12
Restart the computer.
Reference

Using the Ethernet Interface

The Ethernet interface of the machine supports the following three types.
Note
This section describes the installation procedures for the Ethernet interface.
1
Press the push-button power switch to switch off the power.
2
Make sure that the touch screen is blank and the <Power Saver> button is not lit.
3
Open the front cover.
4
Press the main power switch to the [ ] position to switch off the main power.
22
For more information on setting items, refer to "Printer Environment Settings" (P.373).
1000BASE-T
100BASE-TX
10BASE-T
The machine supports IEEE802.3az (a compliance standard of wired LAN) which reduces the power
consumption of the Ethernet equipments while suspending data transmission. To use this feature, both of
the equipments need to support IEEE802.3az.