Perpendicularity - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Appendix
7
Select [Paper Supply].
8
Select the tray in which you loaded paper in step 1, and then select [2 Sided] or [1 Sided],
output color, and the number of sheets.
9
Press the <Start> button.
The sample printout is printed.
10
Select [Save].
11
Select [Close].
12
Check the sample printout, and adjust the position if it is misaligned.
If the printing position of the sample image is correct, a line is printed at a position 10 mm
from the edge of the paper. If the position of the line is misaligned, adjust the paper
registration.
13
After you complete adjustment, print another sample printout and check the adjustment
results.
14
Adjust the paper registration again if necessary.
15
Select [Save].

Perpendicularity

Adjust image skewing (squareness) in 0.1 mm increments.
1
Check the sample printout, measuring the amount of squareness misalignment.
2
Select [Perpendicularity].
16
3
Enter the adjustment value.
4
Select [Save].
Slow Scan %
Adjust the size (scale) of the image in the paper feed direction in 0.025% increments.
754
Note
For Perpendicularity, select paper of A3 size.
We recommend that you print about 3 sheets to calculate the average value of the variations.
Note
Two are printed on the side 1 and one
paper feed direction.
Reference
For more information on each type of adjustment, refer to the following sections:
For Perpendicularity, refer to "Perpendicularity" (P.754)
For Slow Scan %, refer to "Slow Scan %" (P.754)
For Lead/Side Registration, refer to "Lead/Side Registration" (P.755)
is printed on the side 2 of the sample printout to indicate the