Loading Paper In Tray 5 (Bypass) - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

2
Load and align the edge of the paper against the left edge of the tray, with the side to be
copied or printed on facing up.
Important
Do not load paper above the maximum fill line ("MAX" in the right figure). It may cause paper jams or
machine malfunction.
Note
When using punched paper, load the punched paper as shown in the illustration on the right.
3
Push the tray in gently until it stops.
Important
When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it may cause machine
malfunction.

Loading Paper in Tray 5 (Bypass)

When printing or copying on a size or type of paper that cannot be set in Trays 1 to 4, use
Tray 5 (bypass tray). The following describes the procedures to load paper in Tray 5. For
printings, specify the instructions using the [Paper/Output] tab in the print driver. Also
specify the type of paper to be loaded.
Important
To prevent paper jams and erroneous detection of paper loaded in the tray by the machine, do not take out
paper of a package until the tray runs out of paper.
Note
Carefully fan paper before loading it in a tray. Otherwise, the paper may stick together, resulting in paper
jams, or multiple sheets being fed to the machine simultaneously.
Loading Paper
2
61