Protocol Settings - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

Protocol Settings

Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.
On [Network Protocol Report], you can print a report of protocol settings.
Ethernet Settings
Configure the Ethernet settings.
Ethernet1 - Network Name, Ethernet 2 - Network Name
When two Ethernet interfaces are used, specify the names respectively.
Note
This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
Ethernet - Rated Speed / Ethernet 1 - Rated Speed, Ethernet 2 - Rated Speed
Set the communication speed for the Ethernet interface.
Note
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [Ethernet - Rated Speed] is displayed. When two Ethernet interfaces are used, [Ethernet 1 -
Rated Speed] and [Ethernet 2 - Rated Speed] are displayed.
Auto
Select this to detect the Ethernet transmission rate automatically.
100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
1000 Mbps
Select this to set 1000BASE-T as the default value.
TCP/IP - Common Settings
Configure common settings to use TCP/IP.
Primary Network
When two Ethernet interfaces are used, the name of interface which works as the primary
network is displayed.
Note
The primary network is "Ethernet 1". You cannot set "Ethernet 2" as the primary network.
This item is displayed only when Secondary Ethernet (optional) is installed on the machine. You cannot edit
the setting from here.
Connectivity & Network Setup
239
5