Emptying The Hole Punch Waste Container (For Finisher B1) - Fuji Xerox ApeosPort-VI C7771 Administrator's Manual

11
Close the finisher front door.
Note
If the front door is not closed completely, a message appears and the machine will remain paused.

Emptying the Hole Punch Waste Container (for Finisher B1)

When the optional Finisher B1 is installed and the hole punch waste container becomes full,
a message appears on the touch screen. When the message appears, empty the hole punch
waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
Important
Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you empty the hole punch waste
container.
When emptying the punch waste container, press the <Machine Status> button and check the current status
for the hole punch waste container even when the control panel is lit.
1
Make sure that the machine is not operating, and open the front cover.
2
Lift the top transport cover, and then open the front transport cover of the finisher.
Replacing Consumables
101
3