Table of Contents
Advertisement
XM4 Series Printer
User Manual
4 Configuration on Web Setting Tool
Before doing settings for your printer, be sure that you have a LAN cable. The cable is
connected to the LAN connector of your printer. The LAN connector is an 8-PIN RJ45
type modular connector. Please use the LAN cable of CAT 5 of a proper length to
connect the LAN connector on the printer to a LAN hub as appropriate.
The default static IP address of the printer is 0.0.0.0 and the default listen port is
9100. For the first time, to configure your printer through the web setting tool, you
must still follow the step-by-step instructions below.
4.1 Attaching the power cord
1. Make sure the printer power switch is set to the OFF position.
2. Insert the power supply's connector into the printer power jack.
3. Insert the AC power cord into the power supply.
Important: Use only the power supply listed in the user instructions.
4. Plug the other end of the AC power cord into the wall socket.
Do not plug the AC power cord with wet hands or operate the
printer and the power supply in an area where they may get wet.
Serious injury may result from these actions!
4.2 Connecting the printer to a LAN hub
Use a LAN cable of CAT 5 of a proper length to connect the LAN connector on the
printer to a LAN hub to which your desktop or laptop PC as a host terminal is also
connected.
67
Advertisement
Table of Contents
