Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1939

802.1X Commands
•
If the captive-portal parameter is specified with this command, then the Captive Portal authentication
policy is applied to supplicant traffic. See the
page for more information.
•
Configuring non-supplicant classification policies is only supported on 802.1x enabled mobile ports.
•
Each 802.1x port can have one supplicant policy and one non-supplicant policy for handling 802.1x
and non-802.1x devices, respectively. Configuring a new supplicant or non-supplicant policy over-
writes any policies that may already exist for the port.
Examples
-> 802.1x 3/1 non-supplicant policy authentication
-> 802.1x 4/1 non-supplicant policy authentication pass group-mobility fail
default-vlan
-> 802.1x 5/1 non-supplicant policy authentication group-mobility captive-portal
-> 802.1x 5/10 non-supplicant policy authentication vlan 27 fail vlan 500 default-
vlan
-> 802.1x 2/1 non-supplicant policy authentication vlan 10 default-vlan
-> 802.1x 6/1 non-supplicant policy authentication pass group-mobility default-vlan
fail captive-portal
Release History
Release 6.6.1; command was introduced.Release 6.3.1; capitive-portal parameter added.
Related Commands
802.1x supplicant policy
authentication
802.1x non-supplicant policy
802.1x policy default
show 802.1x device
classification policies
show 802.1x non-supplicant
MIB Objects
alaDot1xAuthPolicyTable
alaDot1xNonSuppPolicy
OmniSwitch 6250 CLI Reference Guide
802.1x captive-portal policy authentication
Configures 802.1x authentication device classification policies for sup-
plicants.
Configures device classification policies that do not perform 802.1x or
MAC authentication for non-supplicants.
Resets the device classification policy to the default policy value for the
802.1x port.
Displays device classification policies configured for an 802.1x port.
Displays a list of all non-supplicants learned on all 802.1x ports.
November 2009
command
page 44-13