Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1953

802.1X Commands
output definitions (continued)
port-control
quiet-period
tx-period
supp-timeout
server-timeout
max-req
re-authperiod
reauthentication
Supplicant polling retry count The number of times a device is polled for EAP frames to determine
Release History
Release 6.6.1; command was introduced.
Related Commands
802.1x
802.1x supp-polling retry
OmniSwitch 6250 CLI Reference Guide
The value of the port control parameter for the port (auto, force-autho-
rized, or force-unauthorized), which is set through the
mand.
The time during which the port will not accept an 802.1X authentica-
tion attempt; the timer is activated after any authentication failure. The
range is 0 to 65535 seconds.
The time before an EAP Request Identity will be transmitted. The range
is 1 to 65535 seconds.
The number of seconds before the switch will time out an 802.1x user
who is attempting to authenticate.
The timeout for the authentication server for authentication attempts.
This value is always superseded by the value configured for the
RADIUS authentication server configured through the
server command.
The maximum number of times the switch will retransmit a request for
authentication information (request identity, password, challenge, etc.)
to the 802.1X user before it times out the authentication session based
on the supp-timeout. The range is 1 to 10.
The amount of time that must expire before the switch requires re-
authentication of the Supplicant on this port. Only applicable when re-
authentication is enabled.
Whether or not the port will be re-authenticated after the re-authperiod
expires.
whether or not the device is an 802.1x client. Configured through the
802.1x supp-polling retry
Configures 802.1X parameters on a particular slot/port.
Configures the number of times to poll a device for EAP frames to
determine whether or not the device is an 802.1x client.
November 2009
command.
802.1x com-
aaa radius-
page 44-27